[Woodworkers] Dust Collector Again

[Roy Shrove]

I would agree that a 5HP system would be better if you intend to have ALL
drops open all the time. You need the extra power and airflow to make up
for Static Pressure loss through the open drops. As long as you minimize
right (90 degree) turns in your system and block/close all unused drops,
you should be fine with a smaller unit. Many people over size their
fans/blowers to make up for poor design decisions. ​

Roy

On Tue, Dec 12, 2017 at 7:58 PM, John Corbett via Woodworkers <
woodworkers at lists.sawdusters.org> wrote:

> Gary, that's a bunch of bunk needing a 5 hp motor for a hobbyist system.
> Start with what you already have then add your 6" piping.  If at a later
> date you're not pleased with the results then you can upgrade your DC as
> you've already upgraded you piping as I understand your post.
>
> I built my system several years back after researching much like you
> have.  What I've come to understand is that head knowledge is good however
> practical knowledge/application is 10x better.  I have had zero problems
> with my system being able to service any of my stationary tool needs.
> Three things that increased my vacuum were the addition of a canister
> filter, using 4" flex tube sparingly and using 6" HVAC piping.
>
> My system consists of a Delta 1.5 hp single stage DC outfitted with a
> canister filter.  All of my lines are 6" HVAC piping to as close to the
> tool as possible.  My longest run is probably 30 - 35 feet to a BS with no
> problem.  The next closer tool and still probably 20 feet away from the DC
> is the jointer and it doesn't have a problem as well.
>
> All my 90 deg. elbows are actually two 45 deg. elbows connected together.
> Out of the wyes I used another 45 deg. elbow if the run was perpendicular
> to the main trunk.  ALL joints were taped with the aluminum foil backed
> tape to include all pipe seams as well.
>
> If you use HVAC piping make sure all of the joints are such that the
> joints don't restrict air flow meaning with your DC on your left, the pipe
> or fitting in your right hand fits inside the pipe or fitting in your left
> hand.  In some cases you'll need a pipe crimper so that the pipe/fitting in
> your right hand will slide into the pipe/fitting in your left hand.
> HD/Lowes should have crimpers.
>
> _______________________________________________
> I want to be one of my friends for a day so I can see how cool it is to
> hang out with me.
> Woodworkers at lists.sawdusters.org
>
> To unsubscribe from this list -
> http://lists.sawdusters.org/listinfo.cgi/woodworkers-sawdusters.org
>
> Address to contact the list ADMIN staff -
> woodworkers-owner at lists.sawdusters.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sawdusters.org/pipermail/woodworkers-sawdusters.org/attachments/20171213/36c01f75/attachment.html>